End-pumped Nd:YVO4 laser with reduced thermal lensing via the use of a ring-shaped pump beam

Di Lin and W. Andrew Clarkson

Index: 10.1364/OL.42.002910

Full Text: HTML

Abstract

A simple approach for alleviating thermal lensing in end-pumped solid-state lasers using a pump beam with a ring-shaped intensity distribution to decrease the radial temperature gradient is described. This scheme has been implemented in a diode-end-pumped Nd:YVO4 laser yielding 14 W of TEM00 output at 1.064 μm with a corresponding slope efficiency of 53% and a beam propagation factor (M2) of 1.08 limited by available pump power. By comparison, the same laser design with a conventional quasi-top-hat pump beam profile of approximately equal radial extent yielded only 9 W of output before the power rolled over due to thermal lensing. Further investigation with the aid of a probe beam revealed that the thermal lens power was ∼30% smaller for the ring-shaped pump beam compared to the quasi-top-hat beam. The implications for further power scaling in end-pumped laser configurations are considered.