2-Chlor-5-methylthiophen

Modify Date: 2024-01-02 18:31:44

2-Chlor-5-methylthiophen Structure
2-Chlor-5-methylthiophen structure
Common Name 2-Chlor-5-methylthiophen
CAS Number 17249-82-0 Molecular Weight 132.611
Density 1.2±0.1 g/cm3 Boiling Point 151.8±20.0 °C at 760 mmHg
Molecular Formula C5H5ClS Melting Point N/A
MSDS N/A Flash Point 51.6±8.5 °C

 Names

Name 2-Chloro-5-methylthiophene
Synonym More Synonyms

 Chemical & Physical Properties

Density 1.2±0.1 g/cm3
Boiling Point 151.8±20.0 °C at 760 mmHg
Molecular Formula C5H5ClS
Molecular Weight 132.611
Flash Point 51.6±8.5 °C
Exact Mass 131.980042
PSA 28.24000
LogP 3.00
Vapour Pressure 4.6±0.3 mmHg at 25°C
Index of Refraction 1.554

 MSDS


Section I.Chemical Product and Company Identification
Chemical Name 2-Chloro-5-methylthiophene
Portland OR
SynonymThiophene, 2-chloro-5-methyl- (CA INDEX NAME)
Chemical FormulaC5H5ClS
CAS Number17249-82-0

Section II.Composition and Information on Ingredients
Toxicology Data
Chemical NameCAS Number Percent (%)TLV/PEL
2-Chloro-5-methylthiophene17249-82-0 Min. 96.0 (GC) Not available.Not available.

Section III. Hazards Identification
Acute Health EffectsHarmful if ingested or inhaled. Minimize exposure to this material. Severe overexposure can result in injury or death.
Irritating to eyes and skin on contact. Inhalation causes irritation of the lungs and respiratory system. Inflammation of the
eye is characterized by redness, watering, and itching. Skin inflammation is characterized by itching, scaling, reddening, or,
occasionally, blistering.
Follow safe industrial hygiene practices and always wear proper protective equipment when handling this compound.
Chronic Health EffectsCARCINOGENIC EFFECTS : Not available.
MUTAGENIC EFFECTS : Not available.
TERATOGENIC EFFECTS : Not available.
DEVELOPMENTAL TOXICITY: Not available.
Repeated or prolonged exposure to this compound is not known to aggravate existing medical conditions.

Section IV.First Aid Measures
Eye ContactCheck for and remove any contact lenses. In case of contact, immediately flush eyes with plenty of water for at least 15
minutes. Get medical attention.
Skin ContactIn case of contact, immediately flush skin with plenty of water. Remove contaminated clothing and shoes. Wash clothing
before reuse. Thoroughly clean shoes before reuse. Get medical attention.
If the victim is not breathing, perform mouth-to-mouth resuscitation. Loosen tight clothing such as a collar, tie, belt or
Inhalation
waistband. If breathing is difficult, oxygen can be administered. Seek medical attention if respiration problems do not
improve.
INDUCE VOMITING by sticking finger in throat. Lower the head so that the vomit will not reenter the mouth and throat.
Ingestion
Loosen tight clothing such as a collar, tie, belt or waistband. If the victim is not breathing, perform mouth-to-mouth
resuscitation. Examine the lips and mouth to ascertain whether the tissues are damaged, a possible indication that the toxic
material was ingested; the absence of such signs, however, is not conclusive.

Section V.Fire and Explosion Data
Not available.
Combustible.Auto-Ignition
Flammability
Flash PointsFlammable LimitsNot available.
47°C (116.6°F).
These products are toxic carbon oxides (CO, CO2), halogenated compounds, sulfur oxides (SOx).
Combustion Products
WARNING: Highly toxic HCl gas is produced during combustion.
Fire Hazards
Not available.
Risks of explosion of the product in presence of mechanical impact: Not available.
Explosion Hazards
Risks of explosion of the product in presence of static discharge: Not available.
Fire Fighting Media
Flammable liquid.
SMALL FIRE: Use DRY chemical powder.
and Instructions
LARGE FIRE: Use alcohol foam, water spray or fog. Cool containing vessels with water jet in order to prevent pressure
build-up, autoignition or explosion. Consult with local fire authorities before attempting large scale fire-fighting operations.
Continued on Next Page
2-Chloro-5-methylthiophene

Section VI.Accidental Release Measures
Spill CleanupCombustible material. Harmful material. Irritating material.
Keep away from heat. Mechanical exhaust required. Stop leak if without risk. Absorb with DRY earth, sand or other
Instructions
non-combustible material. DO NOT touch spilled material. Prevent entry into sewers, basements or confined areas; dike if
needed. Consult federal, state, and/or local authorities for assistance on disposal.

Section VII. Handling and Storage
COMBUSTIBLE. HARMFUL. IRRITANT. Keep away from heat. Mechanical exhaust required. Avoid excessive heat and
Handling and Storage
light. Do not breathe gas/fumes/ vapor/spray.
Information
Always store away from incompatible compounds such as oxidizing agents.

Section VIII. Exposure Controls/Personal Protection
Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapors below their respective
Engineering Controls
threshold limit value. Ensure that eyewash station and safety shower is proximal to the work-station location.
Splash goggles. Lab coat. Vapor respirator. Boots. Gloves. Suggested protective clothing might not be sufficient; consult a
Personal Protection
specialist BEFORE handling this product. Be sure to use a MSHA/NIOSH approved respirator or equivalent.
Exposure LimitsNot available.

Section IX. Physical and Chemical Properties
Liquid. (Clear, light yellow.)Solubility
Physical state @ 20°CImmiscible with water.
1.21 (water=1)
Specific Gravity
Molecular Weight132.61Partition Coefficient
Not available.
Boiling Point155°C (311°F)Vapor PressureNot available.
Not available.Not available.
Melting PointVapor Density
Refractive Index1.54VolatilityNot available.
Not available.Not available.
Critical TemperatureOdor
ViscosityNot available.TasteNot available.

Section X.Stability and Reactivity Data

This material is stable if stored under proper conditions. (See Section VII for instructions)
Stability
Conditions of InstabilityAvoid excessive heat and light.
Incompatibilities
Reactive with oxidizing agents.

Section XI. Toxicological Information
Not available.
RTECS Number
Eye Contact. Ingestion. Inhalation.
Routes of Exposure
Not available.
Toxicity Data
Chronic Toxic EffectsCARCINOGENIC EFFECTS : Not available.
MUTAGENIC EFFECTS : Not available.
TERATOGENIC EFFECTS : Not available.
DEVELOPMENTAL TOXICITY: Not available.
Repeated or prolonged exposure to this compound is not known to aggravate existing medical conditions.
Harmful if ingested or inhaled. Minimize exposure to this material. Severe overexposure can result in injury or death.
Acute Toxic Effects
Irritating to eyes and skin on contact. Inhalation causes irritation of the lungs and respiratory system. Inflammation of the eye
is characterized by redness, watering, and itching. Skin inflammation is characterized by itching, scaling, reddening, or,
occasionally, blistering.
Follow safe industrial hygiene practices and always wear proper protective equipment when handling this compound.

Section XII.Ecological Information
Not available.
Ecotoxicity
Environmental FateNot available.
Continued on Next Page
2-Chloro-5-methylthiophene

Section XIII. Disposal Considerations
Waste DisposalRecycle to process, if possible. Consult your local regional authorities. You may be able to dissolve or mix material with a
combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber system. Observe all
federal, state and local regulations when disposing of the substance.

Section XIV. Transport Information
DOT ClassificationDOT CLASS 3: Flammable liquid.
PIN Number
Proper Shipping NameFlammable liquid, n.o.s.
Packing Group (PG)III
DOT Pictograms

Section XV. Other Regulatory Information and Pictograms
TSCA Chemical InventoryThis product is NOT on the EPA Toxic Substances Control Act (TSCA) inventory. The following notices are required by 40
CFR 720.36 (C) for those products not on the inventory list:
(EPA)
(i) These products are supplied solely for use in research and development by or under the supervision of a technically
qualified individual as defined in 40 CFR 720.0 et sec.
(ii) The health risks of these products have not been fully determined. Any information that is or becomes available will be
supplied on an MSDS sheet.
WHMIS ClassificationCLASS B-3: Combustible liquid with a flash point between 37.8°C (100°F) and 93.3°C (200°F).
(Canada)
EINECS Number (EEC)Not available.
EEC Risk StatementsR10- Flammable.
R18- In use, may form flammable/explosive vapor-air mixture.
R20/21/22- Harmful by inhalation, in contact with skin and if swallowed.
R36/37/38- Irritating to eyes, respiratory system and skin.


SECTION 16 - ADDITIONAL INFORMATION
N/A

 Safety Information

Hazard Codes F+
Risk Phrases 20/21/22-36/37/38
Safety Phrases S26-S36/37/39
HS Code 2934999090

 Synthetic Route

~83%

2-Chlor-5-methylthiophen Structure

2-Chlor-5-methy...

CAS#:17249-82-0

Literature: Lucas, Linda N.; De Jong, Jaap J. D.; Van Esch, Jan H.; Kellogg, Richard M.; Feringa, Ben L. European Journal of Organic Chemistry, 2003 , # 1 p. 155 - 166

~%

2-Chlor-5-methylthiophen Structure

2-Chlor-5-methy...

CAS#:17249-82-0

Literature: Journal of Organic Chemistry, , vol. 14, p. 638,639

 Customs

HS Code 2934999090
Summary 2934999090. other heterocyclic compounds. VAT:17.0%. Tax rebate rate:13.0%. . MFN tariff:6.5%. General tariff:20.0%

 Synonyms

Thiophene, 2-chloro-5-methyl-
2-methyl-5-chlorothiophene
2-Chlor-5-methylthiophen
2-Chloro-5-methyl thiophene
2-Chlor-5-methyl-thiophen
Thiophene,2-chloro-5-methyl
2-Chloro-5-methylthiophene
MFCD01632145
5-chloro-2-methylthiophene
5-methyl-2-chlorothiophene
5-methylthiophen-2-yl chloride